A AimCrane
en

Mouse Polling Rate Test

Is your 1000 Hz mouse actually polling at 1000 Hz? Find out in ten seconds.

100% LocalFree
0 HzSwipe your mouse inside this boxDo fast flicks and circles, like clearing a corner in CS2
Live
0 Hz
Peak rate
0 Hz
What a normal page sees
0 Hz

Gaming mice ship at 125, 500 or 1000 Hz by default; newer wireless models add 2000, 4000 and 8000 Hz modes. Judge by the peak, and treat a reading within about ten percent of the rated figure as a pass.

Keep the mouse moving the whole time. A still mouse sends no reports, and slow tracking pulls the live number down even on a perfectly healthy sensor.

How to check your mouse polling rate

  1. 1 Flick the pointer around the pad the way you would in an aim trainer: fast, wide and continuous. The counter needs a stream of reports, and a lazy wiggle produces a lazy number.
  2. 2 Watch the peak, not the live value. The live rate drops every time your hand pauses, but the peak shows the highest rate the mouse managed, which is the setting it is running at.
  3. 3 Check the second figure against the peak. That lower number is all a regular web page gets after the browser merges reports into frames, and it is why some polling rate tests just echo your 144 or 240 Hz monitor.
  4. 4 If the peak stops at 125 or 500 Hz on a mouse sold as 1000 Hz, open its software (Synapse, G HUB, Armoury Crate and friends) and look at the polling rate setting. Many boards also ship with a lower default on wireless to save battery.

Polling rate questions gamers actually ask

Does 4000 or 8000 Hz actually help in CS2 or Valorant?
It trims the delay between hand and crosshair by a fraction of a millisecond compared with 1000 Hz, which sits far below what anyone can feel. Top players use it because the trims add up with a 360 Hz monitor and there is no downside on a strong CPU. On a mid-range PC it can cost frames in some engines, so try it and keep whichever setting gives you stable FPS.
My mouse is set to 8000 Hz but the test shows around 4000.
The browser and the operating system sit between the mouse and this page, and at very high rates they start merging reports. A peak in the thousands already proves the high-rate mode is active; the exact top figure is better measured with the vendor's own tool.
Why does a wireless mouse read lower than the box says?
Most wireless gaming mice only reach their top rate with the official dongle, on a fresh battery, with a clear line of sight. Bluetooth mode caps far lower, often around 125 Hz, which is why Bluetooth is for travel and the dongle is for ranked.
The live number keeps jumping between 500 and 1000. Is the mouse faulty?
Almost never. The live figure follows your hand speed moment by moment. Look at the peak and at the long-run behaviour: a mouse set to 1000 Hz should hit the high 900s over and over whenever you move fast.
Does polling rate change my sensitivity or DPI?
No. DPI decides how far the cursor travels per millimetre of movement; polling rate decides how often the mouse reports its position. You can run 400 DPI at 8000 Hz or 3200 DPI at 125 Hz, and this test only looks at the second one.

More gaming tools

Mouse Test for Gaming

Dead side button, skipping sensor, wheel that misses a notch: find it here, not mid-match.

Mouse Sensitivity Converter

Same cm/360 in every game, with eDPI and a DPI change built in.

Double Click Test for Gaming Mice

Ghost double clicks lose fights. Catch the worn switch before your next ranked match.